Hello friends,
I have a BBB and I just connected a 320x240 4.3" LCD to it:
5,6,5 mapping to as in many LCD "capes" for this board.
H,V sync and CLOCK.
Nothing is working and have no idea how to enable it. I measured the LCD CLOCK signal and has 108 MHz, obvious too high for my LCD, perhaps excellent to HDMI framer chipset.
Can I enable my LCD without re-compiling the kernel? Asking because this just taken me about 22 hours.
Has anyone some DTBS example to start with?
I use a Debian Wheezy with 3.13 kernel but the same problem on Angstrom.
Thanks very much in advance,
I have a BBB and I just connected a 320x240 4.3" LCD to it:
5,6,5 mapping to as in many LCD "capes" for this board.
H,V sync and CLOCK.
Nothing is working and have no idea how to enable it. I measured the LCD CLOCK signal and has 108 MHz, obvious too high for my LCD, perhaps excellent to HDMI framer chipset.
Can I enable my LCD without re-compiling the kernel? Asking because this just taken me about 22 hours.
Has anyone some DTBS example to start with?
I use a Debian Wheezy with 3.13 kernel but the same problem on Angstrom.
Thanks very much in advance,