Hello, I have made a program to figure out the points of a bolt hole circle. Now what I would like, is to update it to plot the points on a graph and show the graph at the end of the program. That way you could view the points and verify that it is what you wanted.
An example of this is say you have 4 hole that you want in a 4 inch Diameter. It will give you the X and Y locations for each hole. That is what the program does now. Here is the link http://sc.cemetech.net/?xpi=74e33345bfe8a36dc1d7271c7ef75bd4
An example of this is say you have 4 hole that you want in a 4 inch Diameter. It will give you the X and Y locations for each hole. That is what the program does now. Here is the link http://sc.cemetech.net/?xpi=74e33345bfe8a36dc1d7271c7ef75bd4