- jsTIfied and iPad Air (SourceCoder 3)
- 15 Nov 2018 03:13:58 pm Permalink
- Last edited by dave1707 on 15 Nov 2018 10:16:55 pm; edited 2 times in total
I looked at a lot of other jsTIfied and iPad discussions for the past couple of days, but I havenít found anything that helps. I put jsTIfied on my PC a few years ago and as far as I remember everything worked OK. The calculator that shows is the TI 84 Plus Silver Edition. The calculator works just like the real one, so everything is setup OK. I can write a basic program and transfer it to the calculator and run the program. The problem is it wont do anything with an assembler program when I select z80 or ez80 and press the Check button. The Check button changes color for a second, but nothing happens. If I select ez80 C and press Check, it runs and gives me errors which I expect because itís not an ez80 C program. I put jsTIfied on my iPad Air (iOS 12.0.1) and the same assembler program compiles OK with no errors when I select z80 and press Check. The problem with my iPad Air is the calculator part wonít work. On my PC I ran the option to create the jpg image and sent it to the iPad. I sent it one way using Dropbox and another by emailing it to my photos. If I load the ROM from Dropbox, the TI 84 Plus Silver Edition skin shows, but thereís a large black square covering the calculator screen and I canít get the calculator to work. If I load the Rom from photos, a TI 82 skin shows and everything looks OK, but the calculator wonít work. The screen is a white square and if I tap on it, it eventually changes to a normal looking bluish green screen, but it still doesnít work. As I said above, I looked thru a bunch of discussions for hints, but didnít find anything.