I've changed a little bit on how the main program works.
* Removed MathPrint support
* Capitalized the "D"s in "done"
* Changed a section in the data list, it now is the install location of functions instead of whether math print should be enabled (if not done so already)
* Added a built-in command to unsquish squished assembly code in assembly programs
* Removed the built-in command `CRASH`.
I've also made a fork of this program for the TI-84 Plus/SE. In this version 1.03α84, I've added the following built-in commands:
* TIMER_hours_minutes_seconds: Sets a timer for the desired hours, minutes, and seconds.
* STOPWATCH: Starts a stopwatch.
* TIME: Shows the time.
* DATE: Shows the date.
* HWCLOCK: This shows the hardware clock integer.
* UNIXCLOCK: Shows the Unix integer from the Hardware Clock.
If you have any suggestions, comments, or complaints let me know! OwO
* Removed MathPrint support
* Capitalized the "D"s in "done"
* Changed a section in the data list, it now is the install location of functions instead of whether math print should be enabled (if not done so already)
* Added a built-in command to unsquish squished assembly code in assembly programs
* Removed the built-in command `CRASH`.
I've also made a fork of this program for the TI-84 Plus/SE. In this version 1.03α84, I've added the following built-in commands:
* TIMER_hours_minutes_seconds: Sets a timer for the desired hours, minutes, and seconds.
* STOPWATCH: Starts a stopwatch.
* TIME: Shows the time.
* DATE: Shows the date.
* HWCLOCK: This shows the hardware clock integer.
* UNIXCLOCK: Shows the Unix integer from the Hardware Clock.
If you have any suggestions, comments, or complaints let me know! OwO
Please do not call me BioHazard.
