I acquired a TI Voyage 200 about 4 years ago, but the screen started breaking within a few months. At the time, I was entirely oblivious, as I wasn't very well aware of how that calculator worked, and I figured it would be fine. A few weeks later, the screen froze and I was worried that I had some bad assembly code (Remember I had no idea of what was going on) I figured it would be impossible to fix, so I forgot about it for a while. Then last year I (finally) found the right screwdriver to open it up and discovered that the LCD ribbon cable was detached from the circuit board. I was wondering if it would be possible to fix this, and if so, how I should do it. Here are some pictures of the calculator opened up:
Top view:

Side view:

Some people have had success reheating the cable with a soldering iron on a low head with a wide tip - but with it fully detached the main challenge will be lining it up correctly.

This is for the 82, but the same principal might apply.
Sounds good, I will try that. Any suggestions for lining it up? I was thinking I could try to line them up with a magnifying glass, and then tape it down a little on either end so it would stay in place. I'm not sure if that would work, though.
Register to Join the Conversation
Have your own thoughts to add to this or any other topic? Want to ask a question, offer a suggestion, share your own programs and projects, upload a file to the file archives, get help with calculator and computer programming, or simply chat with like-minded coders and tech and calculator enthusiasts via the site-wide AJAX SAX widget? Registration for a free Cemetech account only takes a minute.

» Go to Registration page
Page 1 of 1
» All times are UTC - 5 Hours
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum